Thank71
Contributor
Contributor

I Have three NSX EDGEs in condition "RPC request timeout"

Jump to solution

The Three Edges are working fine, but i cannot update DFW rules, etc.

The "show messagebus messages" command shows:

"cmd conn state: closed"

Is there a way to restore comunication to NSX manager without restart/sync/re-depoly EDGES?

Thanks a lot,

Graziano

1 Solution

Accepted Solutions
tanurkov
Enthusiast
Enthusiast

good

can you mark it please as resolved or helpful to close the loop

Regards Dmitri

View solution in original post

8 Replies
tanurkov
Enthusiast
Enthusiast

Hi

please provide version of NSX , this the edge uses Message bus or VIX ,

what version edges are running ?

0 Kudos
tanurkov
Enthusiast
Enthusiast

and if possible provide output of this commands

  • show messagebus forwarder
  • show log follow
  • show messagebus messages

    esxcli network ip connection list |grep 5671

Regards Dmitri

0 Kudos
Thank71
Contributor
Contributor

Hello,

We run NSX 6.2.7. EDGES are in 6.2.7.

pastedImage_0.png

pastedImage_1.png

0 Kudos
tanurkov
Enthusiast
Enthusiast

SO the issue hire is between vsfwd agent on the ESXI and Edge VM.

can provide out put from the esxcli network ip connection list | grep 5671

check aslo /var/log/vsfwd.log.

and I'm just wondering if vmtools are running

nsxedge> show process list

and definitely you need to do force sync/ reboot the edge

Regards Dmitri

Thank71
Contributor
Contributor

I know, a resync is the answer, I was hoping for a sort of "reconnect" commmand...

0 Kudos
tanurkov
Enthusiast
Enthusiast

well , it advice to do resync.

you can do reconnect , but root password on the Edge is needed,  where you can reboot demon.

the root password is not exposed to the end customers by now.

Regards Dmitri

Thank71
Contributor
Contributor

ok thanks a lot

0 Kudos
tanurkov
Enthusiast
Enthusiast

good

can you mark it please as resolved or helpful to close the loop

Regards Dmitri

View solution in original post