Hi, I'm trying to configure OSPF between an ESG and a Fortigate device, Fortigate use the ospf area id as IP address form, but when I try to configure the ESG with the same area id in IP address form, I can't do that, because the webclient don't allow me to write a dot, even, I try to use REST API but the xml reference says that area id is a number between 0 and a big number, that I don't remember, the NSX documentation says that we can configure ospf id area as a number or in IP address form but I can't.
Any help ??
There are some online videos for integrating a Fortigate with a Cisco router. It shows that a configuration on a Fortigate of 0.0.0.0 will link up to a Cisco router that is configured for Area 0, due to the fact that OSPF sees the actual value in Hex. 0.0.0.50 would convert to area 50 in NSX; 10.1.1.1 converts to area 167837953.
This blog can explain further: https://mellowd.co.uk/ccie/?p=910
There are some online videos for integrating a Fortigate with a Cisco router. It shows that a configuration on a Fortigate of 0.0.0.0 will link up to a Cisco router that is configured for Area 0, due to the fact that OSPF sees the actual value in Hex. 0.0.0.50 would convert to area 50 in NSX; 10.1.1.1 converts to area 167837953.
This blog can explain further: https://mellowd.co.uk/ccie/?p=910