VMware Communities
crustibooga
Contributor
Contributor

Fusion 6 Bridged mode not working

Fusion 6 running on Mac Mini server 2012 - OS 10.8.4 - VM=Turnkey Linux LAMP

There are 2 ethernet ports on the mac. If I use just 1 of them and on autodetect I can then see this VM (has fixed IP) as soon as I try to configure the second interface neither work. I've tried using the non autodetect method, this doesn't work either. Thinking of using Fusion 4 again as this is wasting my time. Any ideas folks?

Cheers

0 Kudos
1 Reply
nancyz
VMware Employee
VMware Employee

crustibooga wrote:

Fusion 6 running on Mac Mini server 2012 - OS 10.8.4 - VM=Turnkey Linux LAMP

There are 2 ethernet ports on the mac. If I use just 1 of them and on autodetect I can then see this VM (has fixed IP) as soon as I try to configure the second interface neither work. I've tried using the non autodetect method, this doesn't work either. Thinking of using Fusion 4 again as this is wasting my time. Any ideas folks?

Cheers

Hi crustibooga,

Could you describe your configuration more detailed? So your setup is like this:

   VM

     |autobridge

Ethernet1           Ethernet2

And when you configure Ethernet2, you could not see your VM. I'm not quit clear about your config.:smileyplain:

Is your Ethernet2 in the same network as your VM?

0 Kudos