VMware Cloud Community
colinj
Contributor
Contributor
‎04-06-2011 11:05 AM
Jump to solution

Can't select network attribute in Orchestrator Client

I'm running Orchestrator 4.1.1 and the vCO Client 4.1.1 and I've run in to a problem. I need to define a network for a workflow attribute (creating a VM). When I select any of the virtual port groups with the vCO client to use them for the attribute the select button is greyed out. Anyone else seen this? Do I need to do anything special when defining an attribute of type VC:Network in the vCO client?

0 Kudos
1 Solution

Accepted Solutions
Burke-
VMware Employee
VMware Employee
‎04-06-2011 11:09 AM
Jump to solution

Are you using a standard portgroup (VC:Network) or a Distributed Virtual Portgroup (VC:DistributedVirtualPortgroup). If dvPortgroup, then you may need to change your type...

If my answer resolved or helped you, please mark it as Correct or Helpful to award points. Thank you!

Visit http://www.vcoteam.info & http://blogs.vmware.com/orchestrator
for vRealize Orchestrator tips and tutorials - @TechnicalValues on Twitter

View solution in original post

2 Replies
Burke-
VMware Employee
VMware Employee
‎04-06-2011 11:09 AM
Jump to solution

Are you using a standard portgroup (VC:Network) or a Distributed Virtual Portgroup (VC:DistributedVirtualPortgroup). If dvPortgroup, then you may need to change your type...

If my answer resolved or helped you, please mark it as Correct or Helpful to award points. Thank you!

Visit http://www.vcoteam.info & http://blogs.vmware.com/orchestrator
for vRealize Orchestrator tips and tutorials - @TechnicalValues on Twitter
colinj
Contributor
Contributor
‎04-06-2011 02:04 PM
Jump to solution

You hit the nail on the head my friend. Thanks!

0 Kudos