Hello,
There is no longer a MUI in VI3. You should be able
to connect to http://esxservername/ and get the UI...
But that is for managing VMs not configuring the ESX
server.
You should be able to connect the VIC direct to the
ESX server by using the root user and specifying the
ESXServerName.
If you can not do either of these, login to the
console and troubleshoot the network.....
esxcfg-vswif -l
esxcfg-route -l
esxcfg-vswitch -l
esxcfg-nics -l
ping outsideHostname
Best regards,
Edward
Hi thanks to both of you for the reply.
For LarsLiljeroth , I forgot to mentionne that it is a stand alone server so there is no Virtual Center Agent.
So for the trouble shooting here's some awnser.
esxcfg-vswi -l :[/b]
Name Port Group IP Address Netmask Broadcast Enabled DHCP
vswif0 Legacy eth0 10.47.102.151 255.255.252.0 10.47.103.255 true false
esxcfg-route -l[/b]
VM Kernel Routes:
Network Netmask Gateway
default 0.0.0.0 Local Subnet
esxcfg-vswitch -l[/b]
Switch Name Num Ports Used Ports Configured Ports Uplinks
vSwitch0 64 0 64
PortGroup Name Internal ID VLAN ID Used Ports Uplinks
Legacy vmnet_0 portgroup1 0 0
Reseau ferme portgroup0 0 0
Switch Name Num Ports Used Ports Configured Ports Uplinks
vSwitch1 64 2 64 vmnic0
PortGroup Name Internal ID VLAN ID Used Ports Uplinks
Legacy vmnic0 portgroup3 0 0 vmnic0
10.47.x portgroup2 0 0 vmnic0
Switch Name Num Ports Used Ports Configured Ports Uplinks
vSwitch2 64 3 64 vmnic1
PortGroup Name Internal ID VLAN ID Used Ports Uplinks
Legacy eth0 portgroup4 0 1 vmnic1
esxcfg-nics -l[/b]
Name PCI Driver Link Speed Duplex Description
vmnic1 06:07.00 e1000 Up 1000Mbps Full Intel Corporation 8254NXX Gigabit Ethernet Controller
vmnic0 07:08.00 e1000 Up 1000Mbps Full Intel Corporation 8254NXX Gigabit Ethernet Controller
vmnic2 03:0b.00 3c90x Down 0Mbps Half 3Com Corporation 3C905C-TX Fast Etherlink for PC Management NIC
ping my pc :[/b]
\[root@LSVMWTEST root]# ping fq001158
PING fq001158.my.domain.com (10.53.43.102) 56(84) bytes of data.
64 bytes from fq001158.my.domain.com (10.53.43.102): icmp_seq=0 ttl=126 time=0.613 ms
64 bytes from fq001158.my.domain.com (10.53.43.102): icmp_seq=1 ttl=126 time=0.342 ms
64 bytes from fq001158.my.domain.com (10.53.43.102): icmp_seq=2 ttl=126 time=0.463 ms
Pin, traceroute, and remote SSH console is wroking pretty good. I don't think it is a network problem...
Any other suggestions ?
