VMware Cloud Community
ayhanozgul
Contributor
Contributor
Jump to solution

esx 3.0 network problem

hi i have hp bl685 i install esx 3.0 and give ip fronm eth0 but know i must give frım eth1 but how can i do this

is there annybody to help..anybody

0 Kudos
1 Solution

Accepted Solutions
Troy_Clavell
Immortal
Immortal
Jump to solution

At the console type:

esxcfg-vswitch -l

This is will give you what pnic is connected to your vSwitches

Then

esxcfg-vswitch -U vmnic0 vSwitch0 (assuming your pNiC in question is using vSwitch)

esxcfg-vswitch -L vmnic1 vSwitch0 (this will bind vmnic1 to your COS)

Keep in mind you will probably have to do this from iLO or in front of the console.

View solution in original post

0 Kudos
2 Replies
Troy_Clavell
Immortal
Immortal
Jump to solution

At the console type:

esxcfg-vswitch -l

This is will give you what pnic is connected to your vSwitches

Then

esxcfg-vswitch -U vmnic0 vSwitch0 (assuming your pNiC in question is using vSwitch)

esxcfg-vswitch -L vmnic1 vSwitch0 (this will bind vmnic1 to your COS)

Keep in mind you will probably have to do this from iLO or in front of the console.

0 Kudos
azn2kew
Champion
Champion
Jump to solution

You can unlink it and link it with eth1 network card. You can use this VMware KB articles to change IP address same concepts.

If you found this information useful, please consider awarding points for "Correct" or "Helpful". Thanks!!!

Regards,

Stefan Nguyen

iGeek Systems Inc.

VMware, Citrix, Microsoft Consultant

If you found this information useful, please consider awarding points for "Correct" or "Helpful". Thanks!!! Regards, Stefan Nguyen VMware vExpert 2009 iGeek Systems Inc. VMware vExpert, VCP 3 & 4, VSP, VTSP, CCA, CCEA, CCNA, MCSA, EMCSE, EMCISA
0 Kudos