Two Questions:
In the Pre/Post commands section of the Backup Exec, I have this in Pre and Post respectively:
"C:\Program Files\VMware\VMware Consolidated Backup Framework\backupexec\pre-backup.bat" myvmjob mail.xyz.corp
"C:\Program Files\VMware\VMware Consolidated Backup Framework\backupexec\post-backup.bat" JOBNAME
where: myvmjob is my backup exec job; mail.xyz.corp is the vm
Is this correct?
what about if I have 2 or more VMs?? how can i specify it in the Pre/Post command section
B: In the BEIM document readme.html it was mentioned that :after I run the browse-start.bat, I have to go to Backup exec Gui and make a selections of what I want to backup in c:\mnt folder; when done browsing , I have to unmount the have to unmount and delete the machine snaphots created by using this command:browse-end.bat myvmjob!
but how can BE find the vmdk mounted points if mountpoint is gone? Is there a mistake in the BIEM doco?
thankjs
nuthin