I had a skyline update last night to 2.0.0.2
This morning I had to change the root password as I mislaid it
So did the usual of doing f10 at the splash screen and adding the usual line on the boot configuration
I then did f10 to continue boot and ran passwd to reset the password
I then rebooted the appliance and it lost its gateway setting on eth0
I then ran /opt/vmware/share/vami/vami_config_net to forcibly add the gateway back which worked and rebooted the appliance and everything works fine except when you run networkctl you get the output below which is configuring and it never goes away. Has anybody seen this
This does not seem to go away even after the appliance has been up for an hour or more
Hi seamusobr1,
Welcome to communities!
Is everything working fine or services not starting ?
---------------------------------------------------------------------------------------------------------
Was it helpful? Let us know by completing this short survey here.
Hi seamusobr1,
Welcome to communities!
Is everything working fine or services not starting ?
---------------------------------------------------------------------------------------------------------
Was it helpful? Let us know by completing this short survey here.
It works ok but twice now we have had to reset the root password on the root collector just wondering if this is an issue?
Hi seamusobr1,
Did you reset the root password twice after upgrading to Skyline Version 2.2 ?
no only once
It seems ok now