tdubb123
Expert
Expert

no access to configure array

i dont have access to configure the array manager. i guess its asking for the navisphere auth info right? Is there anyway I can get something else working?

0 Kudos
4 Replies
Michelle_Laveri
Virtuoso
Virtuoso

Can you give a bit more info about your problem?

Have you installed the SRA for your Clarrion into both SRMs and restarted the SRM service?

Regards

Mike Laverick

RTFM Education

http://www.rtfm-ed.co.uk

Author of the SRM Book:http://www.rtfm-ed.co.uk/2010/03/22/new-administrating-vmware-site-recovery-manager-4-0/

Free PDF or at-cost Hard Copy

Regards Michelle Laverick @m_laverick http://www.michellelaverick.com
0 Kudos
tdubb123
Expert
Expert

yes i have installed the SRA on both sides. but when tryingto configure it, it ask for clarion info. i am not the san admin.

0 Kudos
Michelle_Laveri
Virtuoso
Virtuoso

K. You need credentials - perhaps not full rights to SAN. And you not going to get anywhere with SRM without them...

Regards

Mike Laverick

RTFM Education

http://www.rtfm-ed.co.uk

Author of the SRM Book:http://www.rtfm-ed.co.uk/2010/03/22/new-administrating-vmware-site-recovery-manager-4-0/

Free PDF or at-cost Hard Copy

Regards Michelle Laverick @m_laverick http://www.michellelaverick.com
0 Kudos
tdubb123
Expert
Expert

we are using emx cx380. so I downloaded the SRA (EMC MirrorView SRA)

Is this correct? I am not sure we even use mirrorview

0 Kudos