i dont have access to configure the array manager. i guess its asking for the navisphere auth info right? Is there anyway I can get something else working?
Can you give a bit more info about your problem?
Have you installed the SRA for your Clarrion into both SRMs and restarted the SRM service?
Regards
Mike Laverick
RTFM Education
Author of the SRM Book:http://www.rtfm-ed.co.uk/2010/03/22/new-administrating-vmware-site-recovery-manager-4-0/
Free PDF or at-cost Hard Copy
yes i have installed the SRA on both sides. but when tryingto configure it, it ask for clarion info. i am not the san admin.
K. You need credentials - perhaps not full rights to SAN. And you not going to get anywhere with SRM without them...
Regards
Mike Laverick
RTFM Education
Author of the SRM Book:http://www.rtfm-ed.co.uk/2010/03/22/new-administrating-vmware-site-recovery-manager-4-0/
Free PDF or at-cost Hard Copy
we are using emx cx380. so I downloaded the SRA (EMC MirrorView SRA)
Is this correct? I am not sure we even use mirrorview