SergOO
Enthusiast
Enthusiast

unable to invoke installation due to vcsa is not ready check if rpm installation is completed

Коллеги, решил развернуть vCenter Appliance 6.5. Остался последний шаг и выдает следующее:

unable to invoke installation due to vcsa is not ready check if rpm installation is completed

ervcapp.jpg

shellerrvcapp.jpg

0 Kudos
7 Replies
Forrest666
Contributor
Contributor

Приветствую, удалось решить проблему? Тоже самое выдает.

0 Kudos
Finikiez
Champion
Champion

Добрый день!

У вас аплайнс занесен в прямую и обратную зону DNS? Разрешение работает корректно?

0 Kudos
babukandhasamy
Contributor
Contributor

I too have the same problem

pastedImage_0.png

0 Kudos
CRODR
Contributor
Contributor

I have the same issue...Is there a case open or a fix?

pastedImage_0.png

0 Kudos
MikeTasker
Contributor
Contributor

I am having the same issue of "unable to invoke installation due to vcsa is not ready check if rpm installation is completed".  Did we ever figure out a resolution for this?

0 Kudos
symsym
Contributor
Contributor

Same issue here using the OSX installer. I cancelled step2 and started over using https:<vcenter-ip>:5480

In this case, the screen and forms look slightly different. It works this way.

0 Kudos
acatic
Contributor
Contributor

Sadly no luck here yet.  I tried rebooting the VCSA. Live DNS record exists for VCSA as well.

My setup does not meet minimum specs for sure - 8GB RAM on the host.  However, I was hoping the spec requirements have been bypassed since the VCSA VM has been set up thus far already.

Also, this error is preceded by 'Waiting for RPM Installation to finish (% done.)'  I gather it doesn't even get started, since no numerical % given.

0 Kudos