Hello Guys
I have an issue with some vsan nodes.
When vmotion is done from Node1 to Node3 the VMs keep responding and vice versa, but when I Vmotion to node 2 from node3 or node1 the VMs lose all communication. This only happens with node 2.
The 3 nodes are connected to a Cisco 9300L Switch.
I requested the switch configurations and they are not identical with node 2
Node 1 and Node 3 have these configuration on the switches
vMNIC1
- interface GigabitEthernet2/0/X
- switchport trunk native vlan 40
- switchport trunk allowed vlan 40-42
- switchport mode trunk
- spanning-tree portfast
- spanning-tree bpduguard enable
vMNIC3
- Interface GigabitEthernet1/0/X
- switchport trunk native vlan 40
- switchport trunk allowed vlan 40-42
- switchport mode trunk
- switchport port-security maximum 5
- switchport port-security violation restrict
- switchport port-security
- storm-control broadcast level bps 2m 1m
- storm-control multicast level bps 2m 1m
- spanning-tree portfast
- spanning-tree bpduguard enable
However, node 2 has these settings on the switch ports
vMNIC1 and vMNIC3 (Is the same configuration on the ports)
- interface GigabitEthernet2/0/X
- switchport trunk native vlan 40
- switchport trunk allowed vlan 40-42
- switchport mode trunk
- spanning-tree portfast
- spanning-tree bpduguard enable
I have not been able to solve the problem, I can only think that it is a matter of configuration of the ports that must be configured identically, remove spanning-tree portfast.
The version of ESXi is 7.0.3 U3f and the vCenter 7.0.3
Thanks for your comments
