UniqueUser
Contributor
Contributor

Selective multi-monitor only works in certain configurations

My question is similar to the following article, except the issue does not relate to a gap between the relative display co-ordinates.

Selective multi-monitor does not work when two monitors (with a gap) of four monitors are selected (59552) https://kb.vmware.com/s/article/59552


Contrary to the above article nvidia control panel does allow exact snapping of display co-ordinates to the primary monitor. The following example despite being snapped adjacently results in the error "Selective Multi-Monitor mode only applies to adjacent monitors":

UniqueUser_1-1664321214461.png

UniqueUser_2-1664321540849.png

Device: \\.\DISPLAY1
(5120 x 1440 x 32 bpp) 120Hz default up, attached, primary (0,0)
Device: \\.\DISPLAY2
(1680 x 1050 x 32 bpp) 59Hz default up, attached (3498,-1050)
Device: \\.\DISPLAY3
(2560 x 1440 x 32 bpp) 59Hz default up, attached (938,-1440)

 

However in this configuration the Selective Multi monitor seems to work fine

UniqueUser_0-1664321164659.png

UniqueUser_3-1664321610477.png

Device: \\.\DISPLAY1
(5120 x 1440 x 32 bpp) 120Hz default up, attached, primary (0,0)
Device: \\.\DISPLAY2
(1680 x 1050 x 32 bpp) 59Hz default up, attached (2950,1440)
Device: \\.\DISPLAY3
(2560 x 1440 x 32 bpp) 59Hz default up, attached (951,-1440)

 

Any ideas how I can remedy this ?

Labels (2)
0 Kudos
0 Replies