VMware Horizon Community
SAsselin007
Enthusiast
Enthusiast

Horizon 7.12 showing host and cluster greyed out when building an IC pool

Recently installed a new Horizon 7.12 server. Two clusters, 1 mgmt and 1 resources (desktops).

When building an IC pool, at the cluster selection screen, my resource cluster is greyed out and I can't choose it for my pool.

vSphere is 6.7 U3 for the two hosts in mgmt cluster.

my 192.168.3.241 host is running 6.7 U3 as well.

My host is not disconnected or in maintenance mode, even if the message says that. I created new VM's on that host, from vCenter UI, no problem...

Why would the host be greyed out? picture joined

Reply
0 Kudos
4 Replies
sjesse
Leadership
Leadership

Instant clones require a cluster of at least 2 hosts.

Reply
0 Kudos
SAsselin007
Enthusiast
Enthusiast

That is new as I've done single host cluster in 7.10 and 7.11. Where did you see that?

Reply
0 Kudos
sjesse
Leadership
Leadership

Ha, I never got it to work, but I've never placed the host in a cluster by its self. I checked via the flash interface since I'm not at my lab, but I assume the little exclamation points in the html interface should show the same thing. I'd be curious to see what the message there is stating.

pastedImage_0.png

Reply
0 Kudos
SAsselin007
Enthusiast
Enthusiast

that was a good idea, didn't think about going to flash interface.

Getting similar message.

It's weird since my host is neither disconnected or in maintenance mode.

I also went in to to ESXi console and checked the agents. I restarted them just in case (even though the host is showing connected in vCenter and I can start and stop any VM's on that host).

VMware Knowledge Base

Outside of moving that host to my mgmt cluster, not sure what else to try...

Annotation 2020-04-02 092632.jpg

Reply
0 Kudos