Good morning friends!
I am having problems with HBA, it has degraded status.
I checked the settings and showed me the log below.
Could someone help me with this?
It doesn't seem to be an issue with the HBA as the link state is active, however the host cannot see the lun via this hba. Can you try to unpresent the lun from storage to the the host and represent it , then rescan hba.
What is the HBA card make and model?
What is ESXi version ?
can you post the output of this command esxcfg-scsidevs -a
Is the HBA driver is upto date ?
What is the status of HBA shown in GUI ?
Hi, friend, thanks for the feedback!
The version is updated, follow the attachments below, thanks!
Vmware Version ESXi 6.0.0 build-5224934
Driver :
driver: qlcnic
version: 6.1.191
firmware-version: 4.18.4
bus-info: 0000:05:00.0
vmhba0 ahci link-n/a sata.vmhba0 (0000:00:1f.2) Intel Corporation Patsburg 6 Port SATA AHCI Controller
vmhba1 megaraid_sas link-n/a unknown.vmhba1 (0000:03:00.0) LSI / Symbios Logic MegaRAID SAS SKINNY Controller
vmhba2 qlnativefc link-up fc.20000024ff5eaf04:21000024ff5eaf04 (0000:42:00.0) QLogic Corp ISP2532-based 8Gb Fibre Channel to PCI Express HBA
vmhba3 qlnativefc link-up fc.20000024ff5eaf05:21000024ff5eaf05 (0000:42:00.1) QLogic Corp ISP2532-based 8Gb Fibre Channel to PCI Express HBA
vmhba32 ahci link-n/a sata.vmhba32 (0000:00:1f.2) Intel Corporation Patsburg 6 Port SATA AHCI Controller
vmhba33 ahci link-n/a sata.vmhba33 (0000:00:1f.2) Intel Corporation Patsburg 6 Port SATA AHCI Controller
vmhba34 ahci link-n/a sata.vmhba34 (0000:00:1f.2) Intel Corporation Patsburg 6 Port SATA AHCI Controller
vmhba35 ahci link-n/a sata.vmhba35 (0000:00:1f.2) Intel Corporation Patsburg 6 Port SATA AHCI Controller
vmhba36 ahci link-n/a sata.vmhba36 (0000:00:1f.2) Intel Corporation Patsburg 6 Port SATA AHCI Controller
vmhba37 iscsi_vmk online iscsi.vmhba37 iSCSI Software Adapter
It doesn't seem to be an issue with the HBA as the link state is active, however the host cannot see the lun via this hba. Can you try to unpresent the lun from storage to the the host and represent it , then rescan hba.
Can you give me an aid how to do this?
Some doc?
Thank you for this great help!
Sorry I dont have any document. You may involve storage team to do the task as it has to be done from storage side. In case if you do not have a dedicated team , you can refer the documents available from the storage vendor site on that as the steps vary from one storage to another.