Hi all,
Hope I'm posting this in the right place here...
I'm new to the CLI etc, so forgive me if I'm being dumb!
I have VSphere CLI installed, and connecting to our ESXi box with resxtop isnt a problem. In interactive mode, if I press "v" I get the "disk vm screen". Obviously columns depend on configuration, but the rows shown are:
hosted-vm1
hosted-vm2
idle
system
busybox.4398
helper
hostd.4702771
If I run resxtop in batch mode, I get stats for the last 5 of the above - ie, none of the stats for each of the hosted VMs - which would be rather nice!
Also, when I run in batch, information from the "disk device" screen seems to be broken down into far more detail. For example, in interactive a device is shown as "mpx.vmhba:C0:T0:L0, while in batch mode there are multiple entries, such as "vmhba1:C0:T0:L0-2916812" (with the 2916812 bit varying). Could someone explain this for me please?!
Any (simply worded!) advice for a newbie would be welcomed!
Thanks
