I'm using different versions of vsphere to install and not able to since vsphere don't see the raid created by lsi sas9260-8i. Any suggestion ?
You probably have to load the drivers on your host. You can download the drivers from the compatibility site: VMware Compatibility Guide - I/O Device Search and search for your card. You can login to the host and run esxcli software vib install -d megaraid_sas-6.604.54.00-1948917.zip -just replace .zip with the proper drivers you downloaded.
minor76, how can I login to the host since I can't even get to install it yet ?
Can you try installing ESXi 5.0 (or 5.5)? I had this controller and I remember it was detected with all arrays. I did not have to do anything special during installation. I do not have it anymore so I can not test if ESXi 6.0 can detect it (and arrays)...
btw when you jumpt to controller-bios (webios or how it is called) during boot-up, do you see arrays? Are they initialized?
JarryG, I tried to use 5.0, 5.5, 6.0u1, but it's still the same thing, can't see the raid drive. As for raid bios, the array is initialized, and showing the array. At first I thought the same too that the array was not created or initialized, but I checked and double checked and pretty sure the array is there and initialized.
What brand of server are you using?
minor76, Supermicro X9SCL/X9SCM Xeon E31230 3.20GHz 16gb
Depending on the brand of server you are using, you can grab the vendor ISO which will have the raid drivers imbedded into the image.
minor76, where do I go to get this ISO ?
Check this site out and create your own ISO image.
https://matthill.eu/tutorials/add-drivers-to-a-vmware-esxi-iso/
minor76, I have tried this way and still not able to do the installation. So I have decided to just use singe drive instead of raid. Thanks for everyone help.
I have this card As 9260cv-8i and it has been workin until 6.7 but I have upgraded to 7 and it doesn't work.