I'm trying to set a home lab for NSX-t 3. I had my Dell Precision directly connected to my home router and it was working fine. However I tried to change it I connected a Cisco 3560 to my regular ISP home router and my ESXI server to the switch. My home network has a 192.168.0.0/24 addressing and I configure my server with the ip 172.16.0.2. I configured the interfaces of the switch as regular IP interfaces, disable switch port and I can ping the server from my personal computer but I cant ssh. I keeps trying but it does not give any results, I cant connect via web either. I hope you guys help me setup this lab correctly.
First off, I assume SSH service in the ESX host is enabled and running, correct?
Next, being that it's a single host I'm assuming that you do not have a vCenter and are using a virtual standard switch (VSS) for your ESX networking. If so, are you putting a VLAN ID on the portgroup of the management interface? How is the port on the switch configured, as an access port or trunk?