VMware Cloud Community
itagsurya
Contributor
Contributor
Jump to solution

Storage Array Type Path Config: SATP VMW_SATP_SVC does not support path configuration on ESXi 5.0 u1

Hello ,

Below the out from my  IBM HS22 Blade., is there any issue with PATH config.

esxcli storage nmp path list
sas.5005076b08b7aaa4-sas.a9501097faba7a-naa.600508e0000000007abafa971050a900
   Runtime Name: vmhba0:C1:T1:L0
   Device: naa.600508e0000000007abafa971050a900
   Device Display Name: LSILOGIC Serial Attached SCSI Disk (naa.600508e0000000007abafa971050a900)
   Group State: active
   Array Priority: 0
   Storage Array Type Path Config: SATP VMW_SATP_LOCAL does not support path configuration.
   Path Selection Policy Path Config: {current: yes; preferred: yes}

fc.2fff0000c900009f:2ffd0000c900009f-fc.500507680100b680:500507680130b680-naa.60050768018105afc000000000000df0
   Runtime Name: vmhba2:C0:T3:L2
   Device: naa.60050768018105afc000000000000df0
   Device Display Name: IBM Fibre Channel Disk (naa.60050768018105afc000000000000df0)
   Group State: active
   Array Priority: 0
   Storage Array Type Path Config: SATP VMW_SATP_SVC does not support path configuration.
   Path Selection Policy Path Config: {current: yes; preferred: yes}

Regards,

Surya

if you found this or other information useful, please consider awarding points for "Correct" or "Helpful"
Reply
0 Kudos
1 Solution

Accepted Solutions
kastlr
Expert
Expert
Jump to solution

Hi Surya,

no, there isn't any issue with your path configuration.

This does only mean that this policy doesn't allow additional configuration.

I.e. with NMP Fixed you would be able to configure a preferred path which would allow you to manually distribute the IO load.

Your current configuration doesn't offer such option.

Regards,

Ralf


Hope this helps a bit.
Greetings from Germany. (CEST)

View solution in original post

Reply
0 Kudos
1 Reply
kastlr
Expert
Expert
Jump to solution

Hi Surya,

no, there isn't any issue with your path configuration.

This does only mean that this policy doesn't allow additional configuration.

I.e. with NMP Fixed you would be able to configure a preferred path which would allow you to manually distribute the IO load.

Your current configuration doesn't offer such option.

Regards,

Ralf


Hope this helps a bit.
Greetings from Germany. (CEST)
Reply
0 Kudos