Kweli
Contributor
Contributor

Service Console help 4.x

Hello

I need a little help I want to change what vmnic card the service console uses from the command line how do I do that. I want to disable VMnic0 and at someone point bring up vmnic2.

Thanks for any help you can provide.

**********************************************

Switch Name      Num Ports   Used Ports  Configured Ports  MTU     Uplinks

vSwitch0         128         9           128               1500    vmnic0,vmnic1

  PortGroup Name        VLAN ID  Used Ports  Uplinks

  x.x.x.x             0        4           vmnic0,vmnic1

  Service Console       0        1           vmnic0,vmnic1

  VMkernel              0        1           vmnic0,vmnic1

Switch Name      Num Ports   Used Ports  Configured Ports  MTU     Uplinks

vSwitch1         128         1           128               1500

  PortGroup Name        VLAN ID  Used Ports  Uplinks

  Internal Only         0        0

0 Kudos
1 Reply
weinstein5
Immortal
Immortal

Welcome to the Community - This document will assist you with commands o add and remove vnic form a standard switch - VMware KB: Configuring vSwitch or vNetwork Distributed Switch from the command line in ESXi/ESX


If you find this or any other answer useful please consider awarding points by marking the answer correct or helpful
0 Kudos