Where can I configure smtp mail to obtain alert in my web console? Thank you
You need to go with vCenter -- check the attached image
http://www.vhersey.com/wp-content/uploads/2015/03/vcenter-mailanddb.png
This article should help you
Thank you, but I have esxi 6.5 free e I cannot find "Global > Settings" , can you help me to find it?
You need to go with vCenter -- check the attached image
http://www.vhersey.com/wp-content/uploads/2015/03/vcenter-mailanddb.png
But I have not webclient I have only esxi, why?
Thank you
Don't think its possible..
Free version of ESXI doesn't support SNMP.
Hello, You can try to find out the SMTP setting option the way it is explained in the KB given below:
How to configure SMTP server settings in VMware vSphere 6.0
Thanks
Thank you, but I have versione ESXi 6.5 web and the console is different.
Ok, you have 2 possible web interface? You have Esxi 6.5 free?
Thank you
No I have only one web interface. Where can I find the other? I have only that I have shown in image above. Thank you
1. Install a new firewall rule set (copy smtp.xml to /etc/vmware/firewall)
2. Refresh Firewall ruleset (/sbin/esxcli network firewall refresh)
3. Activate the new rule set in the UI under network > firewall rules
I'm not sure if the words are correct; I have a german UI 🙂
Hint: This addional ruleset will be removed after a restart. You need to save the file on another place and copy it to the same place again (including a ruleset refresh).
Add steps/commands to the file /etc/rc.local.d/local.sh - that should solve the requirement too.
# Copy firewall rule SMTP
cp /vmfs/volumes/your_datastore/smtp.xml /etc/vmware/firewall
# Refresh firewall rules
/sbin/esxcli network firewall refresh
Example-Config of smtp.xml
<!-- Firewall configuration information for SMTP -->
<ConfigRoot>
<service>
<id>smtp</id>
<rule id='0000'>
<direction>outbound</direction>
<protocol>tcp</protocol>
<porttype>dst</porttype>
<port>25</port>
</rule>
</service>
</ConfigRoot>
Perhaps that answer your question?
hi
you can found setting for mail server on
at the top of Datacenter - goto Configure (menu on right side) - choose General - Select Mail server and than click Edit.