Highlighted
Contributor
Contributor

ESXi 6.0

Jump to solution

I have a ESXi host sat in a vCenter Cluster, from a virtualisation layer everything is working fine, VMs are sat on host, can migrate to and from host. All the hosts in the cluster are running the same version of hypervisor, same firmware. Using standard switches, active standby... able to ping the host fine

the problem with the host is the monitoring via OpsView isnt working. Just for this one host. again, the Ops view setup is identical to the other hosts in the cluster...

started with a simple reboot followed by an update of the firmware. changed the VMNICs around, from vmnic1 being the active to 2 being the active...

i can ping the gateway from the host, also able to ping out to the jump box

Any suggestions?

1 Solution

Accepted Solutions
Highlighted
Enthusiast
Enthusiast

I had a similar problem, It was Ops view, we'd cloned a previous host monitoring config.

to fix the issue i deleted the clone and recreated from new

View solution in original post

1 Reply
Highlighted
Enthusiast
Enthusiast

I had a similar problem, It was Ops view, we'd cloned a previous host monitoring config.

to fix the issue i deleted the clone and recreated from new

View solution in original post