VMware Cloud Community
winshenting
Enthusiast
Enthusiast

ESX 4 Network Connection

I just the set up the new ESX 4 Host. During the installation, I did not assign IP address for it. After finishing installation, I go the service console to assign the ip address. However, even that the ip address is configured, the host still could not reach other servers.Please kindly refer to the pics.

Reply
0 Kudos
24 Replies
winshenting
Enthusiast
Enthusiast

1. Install ESX 4. Not Web Access; Via VI, failed.

2. Install ESX 4I. Not Web Access; Via VI, failed.

3. Install ESX 3I. OK.

Why?

My hardware is BL460C G1

Reply
0 Kudos
winshenting
Enthusiast
Enthusiast

In the same environment, Only ESX 3 working. Why? My hardware is BL460C G1; Porcessor: E5420. During installing ESX 4, I found that there is one error about "weasel". What is that? Who can help me with this case? It is so strange.

After installing the ESX 4, I could ping. But I could not telnet or make connection via VI. Who can help me?

Reply
0 Kudos
winshenting
Enthusiast
Enthusiast

It is strange for me at this moment. Pls kindly refer to the steps what I have done before,

1. Config Trunk Port

2. Install ESX3I, working well.

3. Install ESX4I, Web Access Deny; VI Access Deny, Telnet Deny, Ping OK

4. Install ESX4, Web Access Deny; VI Access Deny, Telnet Deny, Ping OK

5. During installing ESX 4, I found that there is one error about "weasel", what is that?

6. My hardware is HP BL460C G1; Processor: E5420

Could someone tell me what weasel is in the ESX4? That is very important for me.

Reply
0 Kudos
timw18
Enthusiast
Enthusiast

Have you tried to update the firmware on your blade?

Reply
0 Kudos
winshenting
Enthusiast
Enthusiast

update the firmware, issue the same

Reply
0 Kudos