I have a esxi 5 install with a Mirror raid that runs a SBS server and I need to add another server to it. I do not have enough space on the current raid. How do I get another drive to show up in esxi? I added the drive and it actually showed up and I was able to create a vm but when I came back it said "failed or error" on drive. I tried to add another drive and it does not show up. I have rebooted the host but no luck. Do I need to do something special to get the drive to show up?
What is your "current raid"? What controller is it on? Have you added the physical drive to the existing RAID set and extended it? or have you Added a single drive? I'm not fully familiar with ThinkServers but after adding the drive then you will most likely have to configure a new volume in the Array/RAID manager usually during bios/boot up.
Are you able to provide any screenshots of your bios/raid config along with the specs of the thinkserver and your current raid config, which controller it is on and steps you have taken after simply inserting a new HDD?
If you found this or any other answer useful please consider the use of the Helpful or Correct buttons to award points.