Hello @all,
after i hav convert succesfull a w2k system with the converter 4.1.0-161418 i can not boot the vm.
all times i have the message "no System found". I start the vm with the System Disk with in repair mode
and create a new mbr but with result .
are these a bug on converter 4.1 with 4.0 or 3.xno problems like this comes up.
Thanks for all postings
Regards
Chris
Check your VM details on check wich kind of SCSI controller you have on the VM (LSI Logic or Bus Logic).
Riccardo Riva
VCP,RHCE,FCNSA
If you found this or other information useful, please consider awarding points for "Correct" or "Helpful". Thank You!
thw vm use the buslogic driver (W2K)
Regards
Chris
Can you verify that partition is set to active?