Hello,
The automatic integrity check in my VDR appliance that ran last night discovered some bad restore points. All the documentation I read says to mark the bad restore points for deletion, then run a manual integrity check. But nowhere does it say how to actually initiate a manual integrity check. Does anyone know how? I'm running VDR 1.1.
Thanks.
Just go to the configuration tab->targets and right-click the target you want to check. select integrity check and that's it.
Just go to the configuration tab->targets and right-click the target you want to check. select integrity check and that's it.
That did it! Thanks very much. Such a simple UI, and still I couldn't figure it out. LOL.