KBricksBuilder
Im learning VMwares NSX loadbalancers currently and I'm not getting through to the website I'm trying to balance, but it works fine if I connect directly to the website. Is there some tool I can use… (Show more)
in VMware NSX
siddharthasingh13
Hi All,   I am trying to updated the 'admin' password on NSX ( NSXv, 6.4) using CLI. I have logged into edge appliance but there is no CLI command to update password.   I have looked into NSX 6.4… (Show more)
in VMware NSX
Chris Mentjox
Hi,   Have a question about the intent-based policy api. When sending this "PATCH" request , nsx-t api check on syntax and some more stuff. If all is ok, you get a 200 OK But that does not say… (Show more)
in VMware NSX
ayadav40
Hi All,   I have one physical host on which i have installed ESXi 6.5, that have 2 physical NIC's and all nested servers are on single NIC which is connected to simple switch which have connectivity… (Show more)
in VMware NSX
Miraculix
Hello,   i am verry new to the vmware NSX-T Data Center technology and have a question about the message exchange. Does NSX-T transmit data to V-Center or other vmware services? Because i was… (Show more)
in VMware NSX
ChrisOk
Hello,   is IPv6 for configuring an VIP address for loadbalancing supported with NSX-T 2.5.1?
in VMware NSX
Vish173
Hello,   Trying to workout a use case why a transport node would belong to two overlay transport zones if the node does belong to the two transport zones, then does it create two TEPs - one for… (Show more)
in VMware NSX
WarlockArg
Hi,     I have a 3-fully-collapsed cluster (3 hosts for transport, management and edge). I noticed that Geneve tunnels between the transport nodes and the edge node don't come up from two of the… (Show more)
in VMware NSX
WarlockArg
Hi everybody,    I'm doing my first implementation of NSX-T and have an issue in the T-0 and T1 Gateways that I think is because a fault of mine.      I deployed a Tier-0 Gateway that manages only… (Show more)
in VMware NSX
jvm2016
Hi All, Can some one check following points and suggest if they are correct   1:nsx-v uses vmkernel port on esxi for TEP .does it hold good good nsx-t also. 2.recommended MTU for nsx-v is 1600… (Show more)
in VMware NSX
parsecdata1
Hello all, we have setup a new environment a couple of months ago and have migrated a few customers from the old to the new.  I attended NSX class many years ago but I know software has changed and… (Show more)
in VMware NSX
Load more items