VMware Support Community
barateau2
Contributor
Contributor
Jump to solution

collector inactive

Issue: Advisor does not show any data or collectors.

Collector in skyline advisor shows correct version 2.1 but status in "inactive".

Looking in Skyline Organisation "manage existing collectors" the collector ID is same as in advisor and state is "unhealthy" and shows version 2.0.

Skyline appliance shows same ID as org and advisor and last seen a few seconds ago.

Looking in the collector log it does seem like the upload work fine.

2019-09-12 15:46:43,505 INFO [pool-4-thread-40] VcChangeCollectionTask [CollectionTask.java:142] [task=VC_CHANGES-FQDN] Successfully uploaded data.

Do i need to deregister collector in appliance and request new token "start over" mapping all the collectors again?

1 Solution

Accepted Solutions
evfernandez
VMware Employee
VMware Employee
Jump to solution

Apologies, barateau2​.

After the collector is deployed, it takes up to 48 hours for Skyline to report any findings. We just checked the backend and it looks like the collector is active and is working fine.

If you have any issues with Skyline, kindly respond to the email we've sent today.

Eddie Fernandez
Manager, Skyline Support

View solution in original post

4 Replies
Yuva_1990
Hot Shot
Hot Shot
Jump to solution

Hi,

Please share the required details using the below smart sheet. I will verify the status of the collector and update you.

Smartsheet Forms

Regards,

Yuvaraj

Skyline Support Moderator

Reply
0 Kudos
evfernandez
VMware Employee
VMware Employee
Jump to solution

Hi barateau2

I am marking this question as correct answer due to inactivity. Please respond to this thread if the issue persists.

Eddie Fernandez
Manager, Skyline Support
Reply
0 Kudos
barateau2
Contributor
Contributor
Jump to solution

I did answer the spreadsheet but I have had no "new" communication after that.

But you can close this as they have promised to add "skyline" to the VMware support portal.

Reply
0 Kudos
evfernandez
VMware Employee
VMware Employee
Jump to solution

Apologies, barateau2​.

After the collector is deployed, it takes up to 48 hours for Skyline to report any findings. We just checked the backend and it looks like the collector is active and is working fine.

If you have any issues with Skyline, kindly respond to the email we've sent today.

Eddie Fernandez
Manager, Skyline Support