1 2 Previous Next 15 Replies Latest reply on Sep 6, 2019 9:46 AM by dougsco01 Go to original post
      • 15. Re: Geneve tunnel down between Edge and Compute N-VDS
        dougsco01 Lurker

        >Compute Transport Node, I configure the default-gateway but don't remember anywhere I could configure any Vlan tagging

         

        I was able to use the uplink profile to apply a vlan tag. The default uplink profiles do not provide a vlan tag. I copied the nsx-default-uplink-hostswitch-profile, included a tag for my tep vlan, then applied the new custom uplink-profile in my Transport Node Profile.

        I was experiencing a similar issue with a failed Geneve tunnel. My edges established a tunnel just fine (edge to edge) so i was confident mtu, vlan tag and trunk was correct. My transport nodes would not establish to each other - nor the edges until i Tagged the vlan via the uplink profile.

        1 2 Previous Next