2 Replies Latest reply on Jul 16, 2019 7:00 PM by ronnie8778

    IP range observed not showing it the network cable was drawn from port 23 and 24

    ronnie8778 Novice

      Hi there,


      I have a VMware cluster and wanted to  connect to a ISCSI network connected to an aruba 2920 24 ports switch left 2 ports which is the last 2 ports (which are sharing with sfp) to use, I plugged in the network cable to port 23 and the vcenter could not pick up the observed range of IP address, and same goes to port 24, however when I plug the cable to another port to test, I managed to get the observed IP range in just few seconds, I check in the switch, there is no VLAN configured, anything that I can change to make it work?


      THank you,