5 Replies Latest reply on May 14, 2019 9:55 AM by BenFB

    UAG 3.2 install via Powershell not using staticv4 address

    hammord Lurker

      Hello.  I am trying to use the PowerShell script to install UAG 3.2.  This will be a huge time saver over the OVF if I can get past the last remaining issue.  When I configure the ini file with a single IPV4 address, the appliance installs, but grabs a DHCP address instead.  I can see the OVF properties is missing the STATICV4 setting that is required when building the appliance using the GUI OVF installation.  Is there an ini file setting to set STATICV4 during the installation?


      Thank you.