We are using lacp on our distributedes virtual switch.
When we create new distributed port Groups, we have to chose our lacp uplink a active uplinks.
Is it possible to configure it so we do not have to go to Teaming and failover and change Active uplinks, by setting lacp uplink as the default active uplink?
It would also be nice if default load balancing could be set to "Route based on IP hash.
Hi
I haven't heard any automated way to achieve this.
We need to do it manually and change it .
Please mark this answer as correct and helpful if this helps you.
regards
Gayathri
Hi
I haven't heard any automated way to achieve this.
We need to do it manually and change it .
Please mark this answer as correct and helpful if this helps you.
regards
Gayathri