3 Replies Latest reply on Nov 6, 2018 7:25 PM by Mskazy

    non-IP hash mismatch - distributed switch 6.5

    Schaedle Enthusiast

      Hi,

       

      I setup a distributed switch v6.5 when I activate the health check I get a warning for teaming and failover.

       

      dvs.jpg

      The distributed port groups are all set to: Route based on physical NIC load. And if I change these this does not affect the warning message.

       

      The ESXi is connected via two 10GB NICs to two different physical switches. (Because of some reasons there is no LACP configured.)

      The management of the ESXi runs over two 1GB NICs on a vSwitch.

       

      Why is there this warning and what may I do? I already did a lot of tests and changes on the VMware and on the hardware side.

       

      Regards Wolfgang