I have a vSphere environment
2 ESXi hosts
Enable vSphere HA
1 VM
Right-Click the VM, Select Fault Tolerance > Turn on Fault Tolerance
Update
unconnected CD/DVD drive
Add VMKernel for vMotion and Fault Tolerance logging.
Now, have a warning
vSphere SMP-FT logging network requires 10 Gigabit Ethernet connectivity. At present, only a single 10 Gb NIC can be allocated to handle SMP-FT logging.
Is this necessary?
Yes.
Check it Kb vmwware with preque:
Fault Tolerance Requirements, Limits, and Licensing
Use a 10-Gbit logging network for FT and verify that the network is low latency. A dedicated FT network is highly recommended.
You can ignoring warning about bandwidth requirements, and test if meets your needs
Recommended config would be 10 GB and Jumbo Frames enabled over the FT Logging network. However, warning is something that can be ignored
Cheers,
Supreet
How to change ignoring warning about bandwidth requirements?
How to change ignoring warning about bandwidth requirements?
Go to Alarms or events view, select warning message and click acknowledge or reset to green alarm will ignore warning message