Running fusion pro 8.1.1 with a windows 7 Enterprise 64bit guest.
I have Cisco anyconnect client v3.1.13015 on the windows 7. The anyconnect failed to connect if I have windows 7 using NAT for networking. It works fine when using bridge mode. So if there any setting I should tweak? The anyconnect VPN works however it is really slow, like 30-sec to load a HTTPS internal site. If I do the same on a physical Windows 7, 8.1 or 10 machine, the same HTTPS page loads immediately. Does not make any difference if I use bridge OR NAT for the network setting. Ideas?
Hi m1xed0s,
Welcome to Fusion forum.
Could you please upload your network traffic capture file during the failure happens in NAT mode ? Thanks a lot.
Sorry, did not reply in time. You just want to check the traffic capture on guest OR host?