5 Replies Latest reply on Jul 6, 2015 12:11 AM by ignosgt

    L2VPN with standalone edge (NSX-V 6.1)

    m-nara Novice
    vExpert

      Hi,

       

      I'm trying to connect VXLAN and VLAN by L2VPN with a standalone edge like following table.

       

      Site-A (vCenter with NSX)L2VPN tunnelSite-B (vCenter only)
      [NSX Edge][Standalone Edge]
      VNI 2005Tunnel 2001VLAN 2001
      VNI 2007Tunnel 2002VLAN 2002
      VNI 2004Tunnel 2003VLAN 2003
      VNI 2001Tunnel 2004VLAN 2004
      VNI 2002Tunnel 2005VLAN 2005

       

      The tunnel status between edges is up, but VMs cannot communicate across the tunnel.

      Why the standalone edge does not have conversion-table ?

       

      On the Site-A, the NSX edge is connected to vlan trunk portgroup which allows "1-4094" and configured as a L2VPN server.

      The vlan trunk portgroup has 5 sub interfaces which are logical switches (vxlan) and configured as a L2VPN server.


      On the Site-B,  the standalone edge is connected to vlan trunk portgroup which allows "2001-2005".

      The [Sub Interface VLAN (Tunnel ID)] is configured like "2001(2001),2002(2002),2003(2003),2004(2004),2005(2005)"..

       

       

      NSX Edge
      L2VPN-Server-0> show service l2vpn conversion-table
      TunnelId     VLAN/VNI     Type
      --------------------------------------
      2001          5005               VXLAN
      2002          5007               VXLAN
      2003          5004               VXLAN
      2004          5001               VXLAN
      2005          5002               VXLAN

       

      Standalone Edge
      nsx-l2vpn-edge> show service l2vpn conversion-table
      TunnelId     VLAN/VNI     Type
      --------------------------------------
      ## no entry