Hi,
there at two alarms that don't have preset values to trigger. In that matter I wonder how to use/configure this to get some sensible messages. If someone could point to some documentation or help understanding this I would be happy
1. "Cannot connect to storage"
In this actual enviroment, this alarm is disabled by default (?). Anyway, I wonder how to configure the trigger on this one. There are three triggers:
a. Lost storage connectivity | Unset | Advanced...
b. Lost Storage Path Redundancy | Unset | Advanced...
c. Degraded Storage Path Redundancy | Unset | Advanced...
The status field have four settings: Unset, Normal, Warning, Alarm. What does these values represent ?
In the Conditions field it's an Advanced settings dialog box - how to use this ? What to put in the "Value" field when adding an advanced alarm setting ? Are there any preset definitions on this ?
2. Cluster high availability error"
This alarm is eneable by default, and like above, I need to know how to configure it.
a. HA host isolated | Unset | Advanced...
b. All HA hosts isolated | Unset | Advanced...
c. HA host failed | Unset | Advanced...
Does someone have some knowledge about this ?
/Regards,
/Kiil
Normal, Warning, Alerts are triggers that you can set for more information you may refer to the Basic System Admin guide from and check page 237
If you found this or other information useful, please consider awarding points for "Correct" or "Helpful".
f10.
VCP3,VCP4,HP UX CSA
Thanks for answering, but the admin guide does not describe configuring/tuning of these alarms. We need to configure this to get some sensible messages...but I don't know how...
/Kiil
Hi Kiil
Have you had a look at the folowing article...
http://communities.vmware.com/docs/DOC-12145
the pdf has some fantastic details on advanced configuration of alarms!
Probably not the answer you are looking for, but it might set you in the right direction 😃
Regards
Adam
Kiil, did you ever figure out what to set the status field to (in order to use the predefined high availability alarm)?
Hi, "Cluster high availability error" alarm, are you able to provide an update on how you setup this alarm ?
Thanks