NTP Configuration in 3.5

[khughes]

I know that in 3.5/2.5 setup there is a ntp configuration that you can do in the VIC for each host. Is that just as reliable as doing it via command line? Wasn't sure if I could just use that or if I should go through my normal routine like I did in 3.0.2 in configuring ntp.

• Kyle

[Troy_Clavell · Accepted solution]

I think either way will work just fine. Updating it through the service console will update the GUI and vice versa.

If doing it though the GUI, make a note of this KB http://kb.vmware.com/kb/1003965 just in case

Message was edited by: Troy Clavell

Added KB

[chukarma]

I used to lean toward the command line side but I would recommend the GUI option now that I have configured 12 hosts with the GUI. It is much quicker and simpler to accomplish the same task.

Daniel

[khughes]

Thanks guys, figured as much but nice to get some reassurance

• Kyle