Steps to setup NetApp arrays for VMware Site Recovery Manager

    Introduction

    The attached document contains the steps involved in setting up the NetApp storage arrays for use with VMware Site Recovery Manager.

     

    Outline

    Site Recovery Manager is a VMware disater recovery product which uses array replication technologies to failover from one site to another.

    This particular document looks at one particular vendor (NetApp) and although the document concentrates on the NetApp simulator, the steps are applicable to physical storage arrays from NetApp also.

    The document will take you through the replication setup steps (SnapMirror) and the snapshot setup steps (FlexClone).

     

    Author:

    Cormac Hogan

    Product Support Engineer

    VMware

     

    Resources:

     

    Disclaimer:

    You use this proven practice at your discretion. VMware and the author do not guarantee any results from the use of this proven practice. This proven practice is provided on an as-is basis and is for demonstration purposes only.